
Chimney removal in Billingshurst for stacks you no longer use or want to maintain. We take the chimney down below the roofline and tile over the gap, with a free quote first.
An unused chimney still needs repointing, flashing and flaunching over the years, and it can let damp into the house. Taking it down removes that upkeep for good. Some people also remove a stack before a re-roof, so the new roof can run straight across.
Most removals take the stack down to below the roof, then the roof is felted, battened and tiled over to match. The chimney breasts inside the house can stay where they are, so there's no structural work indoors and no building mess in your rooms.
If the chimney is shared with a neighbour, you'll need their agreement, and the Party Wall Act may apply. Listed buildings and some conservation areas need consent to remove a chimney. Taking out chimney breasts inside is a different job that needs building regulations approval.
We look at the stack, the roof around it and the loft below, and check whether the chimney is shared. Your free quote covers taking it down, the roofing work to close the gap, scaffolding and taking the old bricks away.
Once the scaffolding is up, we take the stack down brick by brick to below the roofline. The flue is capped and left ventilated to prevent damp, then we lay new felt and battens and tile over the opening to match the rest of the roof.
Tell us what's happening with your roof. We aim to respond the same day, and there's no call-out charge.
We look at the roof, explain what we've found in plain terms and give you a free, no-obligation quote.
We carry out the work we quoted for, then talk you through what we've done before we leave.
It depends on the size and height of the stack, the roof covering that needs matching and the scaffolding required. Removing a small stack on a bungalow costs less than taking down a large chimney on a two-storey house. We give you a free quote after looking at it.
Only with their agreement. A shared stack often serves both homes, and the Party Wall Act may apply to the work. In some cases only your half of the stack comes down, but that needs careful planning. We'll talk you through the options when we visit.
Not if it's done properly. The remaining flue needs capping and ventilating, usually with vents in the chimney breasts inside, so moisture can escape. Without that, condensation can build up in the old flue and show as damp patches. We plan this into every removal.
Taking down a typical stack and tiling over the gap usually takes two or three days once the scaffolding is up. Larger stacks, or roofs with tiles that are hard to match, can take longer. We keep the roof covered overnight so your home stays dry.
We also offer:
Tired of maintaining a chimney you never use? Call us for a free look and a straight answer on removal.